Fixing and buying guide

What this product is and who it is for

This is structural-grade plywood manufactured from Brazilian pine veneers. It is designed for builders, contractors, and serious DIY customers undertaking construction projects that require engineered wood panels with proven strength and durability. The CE2+ classification and EN13986 certification confirm it meets UK and European building standards for structural use. The E1 glue specification means formaldehyde emissions are low, making it suitable for both exposed and enclosed applications.

Sizing, pack contents, and coverage

Each sheet measures 2440mm long by 1220mm wide by 12mm thick. This is a standard metric plywood size commonly used for wall sheathing, floor decking, and roof applications. A single sheet covers 2.98 square metres. Order the number of sheets needed based on your project area, allowing for waste and cutting. Sheets are typically supplied individually or in bundles depending on your order quantity.

• Sheet dimensions: 2440 x 1220 x 12mm
• Coverage per sheet: 2.98 m²
• Thickness: 12mm suitable for stud spacing up to 400mm centres in walls and floors
• Confirm delivery and handling requirements with your merchant, as plywood sheets require flat storage and protection from weather

Compatibility and structural performance

This plywood is rated CE2+ Class 3, which indicates it is suitable for use in humid conditions and has good moisture resistance due to its exterior-grade glue bond. It meets EN636-2S specification, confirming it can be used in applications exposed to weather or high humidity. The structural grading means it can carry load-bearing applications when properly supported. Verify that 12mm thickness is appropriate for your stud or joist spacing; 12mm is typically suitable for centres up to 400mm.

• CE2+ Class 3 rating: suitable for humid and external applications
• E1 exterior-grade glue: low formaldehyde emission and weather resistance
• Meets EN314-2 (glue bond strength) and EN636-2S (moisture performance)
• Check your building design or specification to confirm 12mm thickness is correct for your joist or stud spacing

Pre-installation checks and preparation

Before fixing, inspect sheets for damage, warping, or delamination. Store plywood flat in a dry location and allow it to acclimatise to site conditions for 48 hours before installation. Ensure the supporting structure (studs, joists, or rafters) is square, level, and at the correct spacing. Check that fixings (nails or screws) are appropriate for plywood and the substrate beneath. Cut sheets carefully using a sharp saw to minimise splintering, and seal any cut edges if the plywood will be exposed to weather or high moisture.

• Inspect sheets on delivery for damage or delamination
• Store flat and dry; acclimatise for 48 hours before fixing
• Verify supporting structure is square, level, and at correct spacing
• Use appropriate fixings for plywood thickness and substrate
• Seal cut edges if exposed to weather or moisture