How and where to use guide
Premdor 5 Panel Smooth FD30 Firesheild 762mm x 1981mm x44mm
Typical applications and installation
This FD30-rated door is commonly installed in escape routes, stairwells, plant rooms, and between residential units to slow fire spread and allow safe evacuation. It must be hung in a suitable fire-rated frame and fitted with appropriate fire-rated hinges and hardware to maintain its fire certification. Installation should follow building regulations and the manufacturer's instructions; improper fitting will compromise fire performance. The door is supplied as a blank and requires careful measurement to ensure it fits the prepared opening with appropriate clearances for hinges and latch mechanisms.
- Install only in fire-rated frames with fire-rated hinges and closers
- Suitable for internal use in residential and commercial buildings
- Commonly used in escape routes, stairwells, and compartment walls
- Requires professional fitting to maintain FD30 certification
- Check local building regulations before installation
Handling and on-site storage
Store the door flat or upright in a dry, protected area away from direct sunlight and moisture. Avoid leaning the door at an angle for extended periods, as this may cause warping. Handle carefully during transport and installation to prevent damage to the smooth finish and edges. Keep the door away from wet plaster, fresh paint, and damp conditions until the building is fully dried out, as moisture can affect the door's stability and fire rating.
- Store flat or upright in a dry, sheltered location
- Protect from rain, direct sunlight, and excessive humidity
- Handle with care to avoid damage to edges and surface
- Keep away from wet trades until building is fully dried
Maintenance and fire safety compliance
Once installed, the door requires minimal maintenance. Keep the door and frame clean and free from obstructions. Do not paint over or modify the door in ways that may compromise its fire rating. Ensure the door closes properly and any fitted closers function correctly. Periodically inspect hinges, seals, and the frame for damage. If the door is damaged, contact the manufacturer or a qualified installer to assess whether the fire rating remains valid. Never drill additional holes or make modifications without professional advice.
- Keep the door and frame clean and unobstructed
- Check that the door closes fully and any closers function properly
- Inspect hinges and seals regularly for damage or wear
- Do not modify, drill, or paint in ways that may affect fire rating
- Consult the manufacturer if damage occurs
Limitations and important notes
This door provides 30 minutes of fire protection only when installed correctly in a fire-rated frame with appropriate hardware. It is not suitable for external use or exposed to weather. The FD30 rating applies only to the door itself; the overall fire performance of the opening depends on the frame, hinges, seals, and installation quality. Building regulations compliance is mandatory; always consult local authority guidance and engage a qualified installer. The smooth finish may show dust and fingerprints more readily than textured surfaces.
- FD30 rating valid only with correct frame, hinges, and installation
- Internal use only; not suitable for external or weather-exposed locations
- Fire rating depends on complete door set assembly, not the door alone
- Professional installation and building regulations compliance essential
- Smooth finish may require regular cleaning to maintain appearance